The Event class

(PECL event >= 1.2.6-beta)

Introducere

Event class represents and event firing on a file descriptor being ready to read from or write to; a file descriptor becoming ready to read from or write to(edge-triggered I/O only); a timeout expiring; a signal occuring; a user-triggered event.

Every event is associated with EventBase . However, event will never fire until it is added (via Event::add() ). An added event remains in pending state until the registered event occurs, thus turning it to active state. To handle events user may register a callback which is called when event becomes active. If event is configured persistent , it remains pending. If it is not persistent, it stops being pending when it's callback runs. Event::del() method deletes event, thus making it non-pending. By means of Event::add() method it could be added again.

Sinopsisul clasei

final Event {
/* Constants */
const int ET = 32 ;
const int PERSIST = 16 ;
const int READ = 2 ;
const int WRITE = 4 ;
const int SIGNAL = 8 ;
const int TIMEOUT = 1 ;
/* Proprietăți */
public readonly bool $pending ;
/* Metode */
public add ( float $timeout = ? ) : bool
public addSignal ( float $timeout = ? ) : bool
public addTimer ( float $timeout = ? ) : bool
public __construct ( EventBase $base , mixed $fd , int $what , callable $cb , mixed $arg = NULL )
public del ( ) : bool
public delSignal ( ) : bool
public delTimer ( ) : bool
public free ( ) : void
public static getSupportedMethods ( ) : array
public pending ( int $flags ) : bool
public set ( EventBase $base , mixed $fd , int $what = ? , callable $cb = ? , mixed $arg = ? ) : bool
public setPriority ( int $priority ) : bool
public setTimer ( EventBase $base , callable $cb , mixed $arg = ? ) : bool
public static signal ( EventBase $base , int $signum , callable $cb , mixed $arg = ? ) : Event
public static timer ( EventBase $base , callable $cb , mixed $arg = ? ) : Event
}

Proprietăți

pending

Whether event is pending. See About event persistence .

Constante predefinite

Event::ET

Indicates that the event should be edge-triggered, if the underlying event base backend supports edge-triggered events. This affects the semantics of Event::READ and Event::WRITE .

Event::PERSIST

Indicates that the event is persistent. See About event persistence .

Event::READ

This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.

Event::WRITE

This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.

Event::SIGNAL

Used to implement signal detection. See "Constructing signal events" below.

Event::TIMEOUT

This flag indicates an event that becomes active after a timeout elapses.

The Event::TIMEOUT flag is ignored when constructing an event: one can either set a timeout when event is added , or not. It is set in the $what argument to the callback function when a timeout has occurred.

Cuprins

add a note add a note

User Contributed Notes

There are no user contributed notes for this page.
To Top